Guide

Gutter Cleaning Prices:Published Ranges, Cost Inputs and a Quote Formula for Operators

Gutter cleaning prices for operators: published 2026 ranges by story and linear foot, the labor, drive and overhead costs behind them, and a priced sample job.

By Published Updated

10 min read

Gutter cleaning prices are built from four costs: crew hours on the ladder, drive time, the vehicle and disposal, and a share of overhead, divided by one minus the target margin. Published 2026 data puts a typical job at $163 to $333 (Thumbtack, updated March 31, 2026) and $0.80 to $2.00 per linear foot (Taskrabbit, updated November 1, 2026).

A gutter cleaning business loses money on prices that look reasonable. A flat rate copied from a competitor covers a single-story ranch and not the two-story colonial with six downspouts; a per-foot rate ignores the second worker that a 28-foot ladder requires; and a fall price list carries spring's debris assumptions. FieldRanger makes gutter cleaning software for crews that run on HubSpot, and this guide is one of its pricing and quoting guides. It sets out the published ranges first, then the factors that move a job's time, the sourced cost inputs, a priced two-story job, the price units, the ladder rules that decide crew size, and closes with a quote checklist and the scheduling question.

Four terms carry the arithmetic. A linear foot is one foot of gutter run, measured along the eave. A downspout flush clears the vertical pipe as well as the trough. A minimum charge is the lowest price the business accepts for any visit, whatever the footage. Gross margin is the share of the price left after the direct cost of the job; the gross profit margin guide sets out the formula.

Published gutter cleaning prices in 2026

Two consumer marketplaces publish national figures from their own platforms. They measure different things, so the comparison below keeps each source's own units.

Published gutter cleaning prices, as stated by each source (checked November 12, 2026)
MeasureThumbtack, updated March 31, 2026Taskrabbit, updated November 1, 2026
Typical job$163 to $333; most pay around $233$120 to $300 for a home of 150 to 200 linear feet
Single-story home$135 to $250$130 to $250
Two-story home$160 to $300$150 to $350
Three-story homeNot stated$200 to $450 and up
Per linear footExample only: $1.25 a foot$0.80 to $2.00
Low and high end$98 and $560$80 for about 100 feet; $500 and up for 250 feet or more
Downspout work$10 to $40 to reconnect a downspout$50 to $100 to flush; $30 to $60 per extension

Sources: Thumbtack, gutter cleaning prices; Taskrabbit, gutter cleaning cost.

Thumbtack states that its figures are national estimates from data provided by its pros and additional research. Taskrabbit's figures come from its own platform, and it lists an average Tasker rate of $37 an hour. Neither source describes the crew, the insurance or the equipment behind the price, and a marketplace rate for a single helper is not the rate of an insured two-person crew with a truck. The published ranges are a check on a finished price, not a substitute for building one.

Factors affecting gutter cleaning prices

Every factor that moves a price works through one of three costs: time on site, time on the road, or risk. Listing them by mechanism keeps the quote honest.

Height sets the ladder and the crew. A single-story eave sits within reach of a short extension ladder handled by one person; a two-story or three-story eave needs a longer ladder, more moves along the house and, under the ladder rules below, a second worker. Both published sources price three tiers by story for this reason.

Footage sets the time on the ladder. A house with 180 linear feet of gutter takes longer than one with 120 feet at the same height, and per-foot pricing exists to charge for that difference.

Debris sets the minutes per foot. Packed leaves, pine needles, shingle granules and seedlings take longer to remove than dry leaves, and a clogged downspout adds a flush. Gutter guards change the job: a guard either has to be lifted and refitted or the visit becomes an inspection.

Access and distance set the rest. A steep slope under the eave, a fenced yard, landscaping beds and an hour's round trip each add time that is not spent cleaning. The quote has to carry that time whether or not the customer sees it on the invoice.

Gutter cleaning prices by region and season

Regional differences appear in Taskrabbit's own invoice data: an average gutter cleaning invoice of $133 in Austin and $199 in New York City (Taskrabbit, updated November 1, 2026). Labor cost explains part of the gap, since wages and insurance premiums differ by state; housing stock explains the rest, because a market of two-story homes has more footage at height per job.

Seasonal change works through demand and debris rather than through cost. Leaf drop concentrates bookings in a few weeks of autumn, and the debris per foot is heaviest in the same weeks. A business that keeps one price all year either turns work away in the fall or discounts it in the spring. Two adjustments follow from the mechanism: a debris surcharge for heavy or compacted material, and a second visit sold in spring on a recurring schedule, which fills slack weeks rather than competing for the busy ones. No public dataset tracks gutter cleaning price trends for 2025 or 2026, so a year-on-year claim needs the business's own invoice history.

Labor, drive time and overhead in a gutter cleaning price

The cost inputs below come from federal and insurer data; the job measurements in the next section are sample figures.

Labor starts from a wage. The Bureau of Labor Statistics publishes no gutter cleaning occupation, and the closest group, janitors and building cleaners, had a median wage of $17.71 an hour in May 2025 (BLS Occupational Outlook Handbook, page modified August 27, 2026). Wages are 70.0% of total employer compensation cost in private industry (BLS Employer Costs for Employee Compensation, June 2026, released September 9, 2026). Dividing $17.71 by 0.700 gives a loaded labor cost of $25.30 an hour, which covers payroll taxes and benefits as well as the wage.

The vehicle cost uses the IRS business standard mileage rate of 76 cents a mile from July 1, 2026 (IRS standard mileage rates, updated July 28, 2026).

Overhead here is insurance. Insureon publishes no gutter cleaning figure; window cleaning is the nearest ladder trade it covers, with median annual premiums of $931 for general liability, $1,364 for workers' compensation and $3,001 for commercial auto (Insureon, window cleaning insurance cost, updated September 8, 2026). The three policies total $5,296 a year. Spread across a sample 400 jobs a year, about eight a week, each job carries $13.24.

Gutter cleaning prices breakdown for a two-story house

The job is a two-story house with 180 linear feet of gutter and six downspouts, cleaned by two workers in 1.75 hours on site, with a 16-mile round trip taking half an hour. The measurements, times and disposal cost are sample figures; the rates are the sourced ones above.

Sample two-story gutter cleaning job, costed with sourced rates
LineCalculationAmount
Labor on site and driving2 workers × 2.25 hours × $25.30$113.85
Vehicle16 miles × $0.76$12.16
Bags and debris disposalSample cost$5.00
Insurance share$5,296 ÷ 400 jobs$13.24
Full cost of the jobSum of the four lines$144.25
Price at a 35% margin$144.25 ÷ 0.65$221.92
Price per linear foot$221.92 ÷ 180 feet$1.23

The built price lands inside both published two-story ranges, $160 to $300 on Thumbtack and $150 to $350 on Taskrabbit, and inside Taskrabbit's $0.80 to $2.00 per foot. At a 40% margin the same job prices at $240.42, or $1.34 a foot.

The same formula on a single-story house of 140 feet, one worker, an hour on site and the same drive gives a full cost of $68.35 and a price of $105.15. That figure sits below Thumbtack's single-story range of $135 to $250, and the gap is the case for a minimum charge: the market pays for a visit, and a one-person crew on a short eave earns margin above its cost floor.

Price units: per linear foot, per story and flat rate

Three price units are in use, and each hides a different cost.

A per-linear-foot price scales with footage and ignores height, so it underprices a short run on a tall house. A per-story price scales with height and ignores footage, so it underprices a long ranch. A flat rate for a defined house size is simple to quote by phone and simple to get wrong when the house turns out larger.

The workable combination is a rate per foot by story tier, a minimum charge, and named surcharges for downspout flushing, heavy debris and guards. Converting between units uses the same cost build: the price of the sample two-story job is $221.92, $1.23 a foot or $126.81 per crew hour on site. A quote stated in one unit can be checked in the other two before it goes out.

Ladder rules that set crew size

Federal ladder rules apply to employees, and they add time to every job that uses an extension ladder. Under the OSHA walking-working surfaces standard, ladders are inspected before initial use in each work shift; portable ladders used to reach an upper landing have side rails that extend at least 3 feet above it; the top of a non-self-supporting ladder is placed so that both side rails are supported; and the top step of a stepladder is not used as a step (29 CFR 1910.23, via Cornell LII, checked November 12, 2026).

Those rules turn into minutes. Every move along the house is a ladder set-up, a check of the footing and a climb, and a two-story house with six downspouts can need a dozen moves. The second worker who steadies the ladder and carries debris is a cost in the sample job above, and a price that assumes one person on a two-story house leaves that cost unpaid.

Commercial and rain gutter jobs

Commercial work changes the unit and the paperwork. Property managers buy by the building or by the visit on a schedule, ask for a certificate of insurance before the first visit, and may require after-hours work. Residential searches split by term as well as by house: a rain gutter is the same open K-style or half-round trough, priced by the same linear foot.

Gutter cleaning quote checklist

  1. Measure the linear feet by story tier from the eave line, and count the downspouts.
  2. Note gutter guards, heavy debris, steep ground and fenced access before pricing.
  3. Load the wage: hourly wage ÷ 0.700 for payroll taxes and benefits.
  4. Count crew hours on site and on the road, with two workers wherever the ladder rules require it.
  5. Add the vehicle at the IRS rate, disposal, and the insurance share per job.
  6. Divide the full cost by one minus the target margin, then convert the result to a per-foot rate and a per-hour rate.
  7. Compare the finished price with the published ranges for the same story tier.
  8. After the first month, compare on-site hours per job with the times assumed in the price.

Recurring gutter visits in FieldRanger

Gutter cleaning repeats on a calendar, and the price is only as good as the hours recorded against it. FieldRanger keeps both on the HubSpot record. An estimate is built from the HubSpot deal or contact record, or in FieldRanger and kept tied to the deal, and PandaDoc sends it for signature. A won deal becomes a job with its context carried over, and recurring job templates set the spring and fall visits for customers on a maintenance schedule, as the recurring jobs page describes.

In the field, technicians clock in and out with time logged against each job, which is the measurement step 8 of the checklist needs. FieldRanger builds each technician's route for the day automatically, the dispatcher reschedules rain delays by dragging jobs on the calendar, and the invoice is generated from the completed work order. Payment can be taken in the field through Stripe, invoices and payments sync with QuickBooks, and revenue reports show job revenue and margin by customer or service type. Plans are listed on pricing, and Start free trial runs 14 days with no card.

Frequently asked questions

How much do gutter cleaning companies charge?

Thumbtack's March 2026 data puts a typical job at $163 to $333, with a single-story home at $135 to $250 and a two-story home at $160 to $300. Taskrabbit's November 2026 figures put per-foot pricing at $0.80 to $2.00 a linear foot.

How to price gutter cleaning per linear foot?

Cost the job first: loaded labor hours on site and on the road, the vehicle at the IRS mileage rate, disposal and an insurance share. Divide by one minus the target margin and then by the footage. The sample two-story job in this guide came to $221.92, or $1.23 a foot at a 35% margin.

What factors affect gutter cleaning prices?

Height, footage, debris, guards, downspouts, access and distance. Each works through time on site, time on the road or ladder risk, so a two-story house with heavy debris prices above a single-story house of the same footage.

Are gutter cleaning prices higher in the fall?

Demand and debris both peak during leaf drop, so the time per foot rises and the schedule fills. A debris surcharge prices the first effect; selling a spring visit on a recurring schedule moves work out of the busiest weeks.

How much does gutter cleaning cost by region?

Taskrabbit reports an average gutter cleaning invoice of $133 in Austin and $199 in New York City. Local wages, insurance premiums and the share of two-story homes account for differences of that size.

Should a gutter cleaning business charge a minimum?

The sample single-story job in this guide had a full cost of $68.35 and priced at $105.15 on cost, below Thumbtack's single-story range. A minimum charge covers the drive and set-up of any visit and keeps short jobs from pricing below the market.

The figure to know before quoting a two-story house is not the market's $160 to $300: it is $144.25, the cost of two workers, a truck and an insurance share on 180 feet of gutter.

Run field service on HubSpot with FieldRanger

Estimates with e-signature, scheduling and dispatch, a technician mobile app and invoicing, synced to the HubSpot deals and contacts the business already keeps.

Book a demo