Guide
Handyman Plumbing Prices:Unlicensed Plumbing Limits in North Carolina, Florida and Ohio, Published Task Ranges, Wage Gaps and a Greensboro Visit
Handyman plumbing prices for the tasks a handyman may do without a plumbing license in North Carolina, Florida and Ohio, with dated ranges and a sample visit.
Handyman plumbing prices start with the state's licensing line, not the market rate. Published ranges put toilet repairs at $60 to $200 and kitchen faucet installs at $150 to $400, but a handyman may price only the plumbing tasks the state leaves unlicensed. In North Carolina that is drain cleaning and minor part replacements; water heaters need a plumbing license.
A handyman's plumbing price list fails when it lists work the business may not legally do. A Greensboro handyman quotes a water heater swap, which North Carolina's plumbing board rule reserves to licensed plumbers in any structure. A Hillsborough County handyman relies on Florida's $2,500 minor-work exemption and misses the county's statement that only a licensed plumbing contractor or the owner may perform even the permit-free leak and toilet work. This guide is one of the pricing and quoting guides from FieldRanger, which builds handyman software on HubSpot. It sets out the licensing line in North Carolina, Florida and Ohio from each state's own text, then the published price ranges and the wage gap between handymen and plumbers. A priced Greensboro visit, the wording of the price list, a checklist and the job records in FieldRanger follow.
Three terms carry the argument. A plumbing license is the state credential for the business of plumbing; this guide uses the word as each statute does. A minor-work exemption lets an unlicensed person do work below a value or of a defined kind. A permit exemption is a different thing: it says the building department needs no permit for a task, and it does not by itself say who may do the task.
North Carolina: G.S. 87-21(c) and the board's minor repair rule
North Carolina defines the plumbing business broadly and carves out two kinds of handyman work. The licensing article applies to "the installation or replacement of condensing units, air handlers, gas furnaces, package units, boilers, water heaters, heat exchangers, or whole-house water purification or treatment systems, as well as the connection, repair, or alteration to the plumbing drainage, waste, or venting system or the potable water system". It "shall not apply to those who clean plumbing drains or those who make minor repairs or minor replacements to an already installed system", and minor repairs "include the replacement of parts in an installed system which do not require any change in energy source, fuel type, or routing or sizing of venting or piping" (G.S. 87-21(c)) (North Carolina General Statutes § 87-21, read November 13, 2026).
The State Board's rule then narrows "minor" (21 NCAC 50 .0506, minor repairs and alterations, read November 13, 2026):
- "The initial installation or the subsequent replacement of any water heater in any structure requires a license in plumbing", except an owner installing one personally in property not for sale or rental (.0506(b)).
- A connection, repair or alteration that interrupts the potable water supply and, if poorly performed, risks contaminating it is not minor (.0506(d)).
- Work that, if poorly performed, risks fire or exposure to carbon monoxide, open sewage or other gases is not minor (.0506(e)).
- A task the rule does not list is not minor merely because it is not listed (.0506(f)).
The fourth rule decides the handyman's price list. North Carolina names drain cleaning as exempt and part replacement as minor, and leaves every other plumbing task to the board's tests.
| Task | Reading under G.S. 87-21(c) and 21 NCAC 50 .0506 | Published price |
|---|---|---|
| Clear a sink drain with a hand auger | Exempt: the statute names those who clean plumbing drains | Kitchen drain snaked, $100 to $300 |
| Replace a toilet flapper | Minor: a part in an installed system, no change in routing or sizing | Toilet repair, $60 to $200, average $125 |
| Replace a toilet fill valve | Part replacement on the potable supply; the contamination test in .0506(d) reaches it | Within toilet repair, $60 to $200 |
| Replace a kitchen faucet on existing lines | Interrupts the potable supply; .0506(d) applies, and .0506(f) withholds an exemption by silence | $150 to $400, average $300 |
| Replace a garbage disposal | Touches the drainage connection the statute names | $300 to $600 installed; handyman labor $150 to $375 |
| Replace a water heater | License required in any structure under .0506(b) | Not a handyman price |
| Move a sink supply line | Alters routing of the potable water system | Faucet relocation, $600 to $800 |
The prices come from Fixr's cost pages for toilet repair, kitchen faucet installation, garbage disposal installation and unclogging a kitchen sink, each read November 13, 2026. They mix plumber and handyman prices, so they mark the market a customer compares against rather than a handyman's own rate. The rows marked with a board test are tasks the text does not settle; the State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors answers them, and a handyman prices them only after that answer.
Florida: the $2,500 exemption, permits and county rules
Florida's contractor statute exempts "any work or operation of a casual, minor, or inconsequential nature in which the aggregate contract price for labor, materials, and all other items is less than $2,500". The exemption does not apply where the work is part of a larger operation or split into contracts under $2,500 to evade the law, or "to a person who advertises that he or she is a contractor or otherwise represents that he or she is qualified to engage in contracting" (s. 489.103(9), F.S.) (Florida Statutes § 489.103, read November 13, 2026). The Department of Business and Professional Regulation adds a condition in its FAQ: "Typically, work requiring a permit is not of a casual, minor, or inconsequential nature", and it directs contractors to the building department (Florida DBPR, construction industry FAQs, read November 13, 2026).
The county page can close the door the state left open. Hillsborough County lists the plumbing work that needs no permit: stopping leaks in drain, water, soil, waste or vent pipe; clearing stoppages; repairing leaks in pipes, valves or fixtures; and removing and reinstalling a toilet where no valves, pipes or fixtures are replaced or rearranged. It then states that "only a licensed plumbing contractor or the property owner can perform all work described for leaks and water closets regardless of whether a permit is required" (Hillsborough County, work exempt from permits, last modified June 29, 2026). The same page notes that the $7,500 permit exemption for single-family work under House Bill 803 does not apply to plumbing.
For a handyman working under Hillsborough County's building department the price list therefore holds no plumbing line at all, even below $2,500 and even for permit-free work. Cities inside the county, and other Florida counties, publish their own permit lists, and each one is read before the price list is printed.
Ohio: a state license for commercial projects, local rules for houses
Ohio's construction industry licensing board licenses plumbing contractors, and "no person shall act as or claim to be a type of contractor that this chapter licenses" without that license (R.C. 4740.13(A)) (Ohio Revised Code § 4740.13, read November 13, 2026). The chapter's "construction project" excludes "a residential building as defined in section 3781.06" (R.C. 4740.01(F)) (Ohio Revised Code § 4740.01), and that section defines a residential building as "a one-family, two-family, or three-family dwelling house" with its accessory structures (Ohio Revised Code § 3781.06).
The state license therefore governs plumbing on commercial and larger residential buildings, and a handyman who holds out as a plumbing contractor on such a project needs it. For a house of up to three units the state statute does not set the line, so an Ohio handyman checks the rules of each city or county served before writing a plumbing line.
Published handyman and plumber rates and the wage gap
Fixr puts handyman hourly rates at $50 to $100, "with most charging around $65 an hour", and lists a bathroom faucet swap with the homeowner supplying the faucet at around $75 as its low-cost example (Fixr, handyman cost, updated January 30, 2025). Its garbage disposal page sets plumbers at $75 to $200 an hour and a handyman at $50 to $125 an hour for the same installation.
Wage data shows what sits under those rates. In the Greensboro-High Point area, the median annual wage is $47,320 for general maintenance and repair workers and $57,510 for plumbers, pipefitters and steamfitters, on BLS 2025 wage data (O*NET, 49-9071 North Carolina wages; O*NET, 47-2152 North Carolina wages, read November 13, 2026). Divided by 2,080 hours, those medians are $22.75 and $27.65 an hour. The licensed trade's labor costs about $4.90 an hour more at the median, and the license is what the customer buys with it on the tasks reserved to plumbers. The handyman prices guide builds an hourly rate from cost; this guide applies a rate to the plumbing tasks that are legal to sell.
Sample Greensboro visit priced at a sample $75 an hour
The sample is invented: a Greensboro, North Carolina handyman business charging a sample $75 an hour with a one-hour minimum, parts at cost plus 25 percent, and three tasks on one visit, all inside the statute's named exemptions. The times and part costs are sample inputs.
| Line | Sample basis | Sample price |
|---|---|---|
| Clear bathroom sink drain with a hand auger | 0.75 hours at $75 | $56.25 |
| Replace toilet flapper | 0.25 hours at $75, plus a $12.00 part at cost plus 25 percent | $33.75 |
| Replace showerhead supplied by the customer | 0.25 hours at $75 | $18.75 |
| Visit total | 1.25 hours, above the one-hour minimum | $108.75 |
The same customer asks for a new water heater and a faucet replacement. The water heater goes to a licensed plumber under .0506(b). The faucet waits for the board's answer on .0506(d), or goes to the plumber with the heater. The referral is written on the work order, so the visit record shows what was declined and why. The handyman invoice template holds the three priced lines and a referral note in its notes field.
Price list wording and the advertising tests
The price list is advertising, and each state's test reads its words. Florida withdraws the exemption from a person who "advertises that he or she is a contractor". Ohio's contractor definition turns on whoever "advertises, or otherwise holds out" as permitted to do a licensed trade. North Carolina's article applies to those who "engage in, or attempt to engage in, the business of plumbing". A list headed "Plumbing" that offers "all plumbing repairs" holds out the whole trade. A list headed "Drain clearing and fixture parts" that names the tasks priced, with "water heaters and new piping referred to a licensed plumber", describes only the exempt work. The electrical handyman prices guide applies the same wording test to electrical work.
Handyman plumbing price list checklist
- Read the state's plumbing licensing statute and any board rule on minor repairs on the state's own site, and record the date.
- Read the county or city permit-exemption page for each place served, including any statement about who may do permit-free work.
- List the plumbing tasks the business offers and mark each as exempt by name, minor by the rule's tests, unsettled, or licensed.
- Ask the state board in writing about each unsettled task, and keep the answer.
- Price only the exempt and confirmed tasks; write the licensed tasks as referrals.
- Head the price list with the tasks it names, not with the word "Plumbing".
- Compare each price against a published range with its date.
- Verify: send a test estimate and a test invoice through the job system and confirm that no licensed task appears as a priced line and that each referral is recorded on the work order.
Plumbing lines, referrals and job times in FieldRanger
An estimate is built from the HubSpot deal or contact record without leaving HubSpot, or in FieldRanger and kept tied to the deal. Each job is assigned to one handyman on a digital work order, and skill-based assignment matches jobs to technicians by certification and expertise, so a water heater job can go only to a licensed plumber on staff. Clock-in and clock-out time is logged against each job, which turns the sample times above into measured ones. The invoice is generated from the completed work order, and revenue reports show job revenue and margin by service type, so drain clearing and fixture-part lines can be priced from their own history. The handyman invoice template suits a business not yet on software.
Pricing has the plans; Start free trial runs 14 days and asks for no card.
Frequently asked questions
How much does a handyman charge for plumbing?
Published ranges put handyman labor at $50 to $100 an hour, toilet repairs at $60 to $200 and kitchen faucet installs at $150 to $400, on Fixr pages updated in 2025. A handyman prices only the plumbing tasks the state leaves unlicensed.
Can a handyman do plumbing in North Carolina?
Only drain cleaning and minor repairs, meaning replacement of parts with no change in energy source, fuel type, or routing or sizing of piping or venting. The board's rule adds that any water heater replacement requires a plumbing license, and that work risking contamination of the water supply is not minor.
Can a handyman replace a water heater?
Not in North Carolina, where the board's rule requires a plumbing license for any water heater installation or replacement, except an owner working on their own non-rental property. In Florida, the licensing board treats work that needs a permit as outside the minor-work exemption, so the local permit rule for water heaters decides.
Can a handyman do plumbing in Florida?
The state exempts casual, minor work under $2,500 that is not advertised as contracting, and its licensing board treats permitted work as outside that exemption. Hillsborough County states that only a licensed plumbing contractor or the owner may do even its permit-free leak and toilet work.
Does Ohio require a plumbing license for handyman work?
Ohio's state plumbing contractor license covers construction projects but excludes one-, two- and three-family dwellings, so residential rules are set locally. A handyman who holds out as a plumbing contractor on a commercial project needs the state license.
The Greensboro visit bills $108.75 for three exempt tasks and hands the water heater, which would have been the largest line on the invoice, to a licensed plumber.
Run field service on HubSpot with FieldRanger
Estimates with e-signature, scheduling and dispatch, a technician mobile app and invoicing, synced to the HubSpot deals and contacts the business already keeps.
Book a demo